Overhead Door Company of Roseburg facebook logo Need Service?

Keypad Programming Instructions

Test Your Garage Door Opener

  • Enter your PIN.
  • Press the button with the [arrow up / arrow down triangles].

Reset / Clear Your Keypad

(Starting over, Forgot PIN or Changing PIN)
  • Press and hold the [PROG] button. Keep holding while you -
  • Press and hold the [6] button. Keep holding while you -
  • Press the key with the [arrow up / arrow down triangles].

Set Your Wireless Keypad PIN

  • Press the following keys in this order: [3] [5] [7] [PROG]
    - Red LED blinds - once per second.
  • Enter your PIN (3 to 8 characters).
  • Pres the [PROG] key again.
    - Red LED blinds - twice per second and turns off.

Programming Door Opener(s):

Before you begin, be aware of the following:

  • For Convenience: Program your keypad BEFORE mounting.
  • If Programming Fails: Follow RESET/CLEAR instructions.
  • Locate the [Learn Code} button and red LED indicator on the back of the motor.

Programming ONE Door Opener

  • Press the [Learn Code] button once. - The red LED indicator will blink.
  • Enter you PIN.
  • Press the [arrow up / arrow down] button on the keypad. The red LED will go steady.
  • Press the [arrow up / arrow down] button a second time. The red LED will go out.
  • Press the [arrow up / arrow down] button a third time. The garage door should move.

Programming 2 or 3 Door Openers

(All Door Openers will use the same PIN)

Programming the Keypad

  1. Enter you PIN and press the [PROG] button.
    - Red LED blinds once per second.
  2. Press the [PROG] button a second time.
    - Red LED blinks twice per second.
  3. Press the total number of Doors you wish to control.
    (Press either [2] or [3]).
  4. Press the [PROG] button a third time.
    -Red LED blinds several times and turns off.

Programming the Door Openers

  1. Decide which door will be Door #1, #2 and #3.
    -Press the [Learn Code] button once. - The red LED indicator will blink.
  2. Enter your PIN and press the [arrow up / arrow down] button once.
    -The red LED continues to blink.
  3. Press the number you have picked for this Door Opener [1], [2], or [3].
    -The red LED will go steady.
  4. Press the [arrow up / arrow down] button a second time.
    -The red LED will go out.
  5. Press the [arrow up / arrow down] button a third time.
    -Door should move.

Repeat Steps 1 through 5 for each door opener. Each door opener must be programmed to receive the signal from the wireless keypad.

Troubleshooting

  • If the garage door does not move, check the red LED on the keypad.
  • If the LED is blinking rapidly, the PIN was entered incorrectly.
  • Any keypad button will control the door for 30 seconds after the door starts moving.
  • Rapid blinking of the LED indicates an error. After a few seconds the LED will turn off and then you can try again.
  • If the red LED does not blink during use, the battery needs to be changed.

Mounting Instructions

  • Remove battery cover.
  • Drill a 1/16" hole for the top mounting screw.
  • Install a screw into the top drilled hole, leaving a 1/8" gap between the screw head and the wall.
  • Hook the keypad over the screw.
  • Mark the bottom hole then screw in the bottom screw.
  • Reinstall the battery cover.

Additional Assistance

Should you need additional information, please contact our customer service department at (800) 491-4802 or locally, dial (541) 673-4802.